Mustang Survival MD0450 - Manual (Page 16)

Re-arming Your PFD
NOTE: A valid re-arm kit (MA7218) is required for this procedure.
1) Place the Inflatable Vest with LIFT TM on a smooth, flat surface and
wipe off any water. Access the inflator by reaching under the cover
and pull it toward you, turning the cell and cover inside-out to fully
expose the inflator for re-arming. Hold the CO
2
cylinder through the
fabric, using one hand (Fig. 12).
FIGURE 12
2) Insert the metal key between the black locking ring and labeled
yellow cap. Turn the key counter-clockwise (Fig. 13).
Locking Ring Key
FIGURE 13
13 MUSTANG SURVIVAL