Marantz ST7001 - Manual (Page 19)

15
ENGLISH
OPERATION
7 Checking the XM signal strength
and Radio ID
1. Press the POWER ON/STANDBY switch q or ON
button , to turn on the power.
2. Watching the display, press the BAND SELECT button
!0 or BAND button c to select the XM mode.
3. Press the DISPLAY button t or . twice. Signal status
is displayed.
• The display changes as shown below according to the
receiving condition.
4. Adjust the antenna location until “SIGNAL:STRONG” is
displayed.
5. Press the TUNING – button ⁄1 to select channel 0
(XM000).
• The Radio ID is displayed.
Note
• If “CHECK ANTENNA” appears in the front panel display,
the XM Connect-and-Play antenna may not be connected
to the XM terminal on the rear panel of this unit properly.
• You can not select channel “0” if the All channel search
mode is not selected.
Display Condition
STRONG Signal strength is good
MARGINAL Signal strength is marginal
WEAK
Signal strength is poor
NO Loss of the signal
Radio ID
REMOTE CONTROLLER
RC7001ST
SHIFT
R E
EN
T
BAND MENU
TUNING
CONTROL
CHANNEL/
A/B C/D E/F
TIMER
10
DISPLAY DIMMER
9 8 7
4 5 6
3 2
T-MODE I/J G/H
SLEEP MEMO
ON STANDBY
1
/A-TUNE
A-PRESET
.
c
⁄1
PUSH ENTER PUSH ENTER
TUNING/PRESET TUNING/PRESET
STEREO STEREO TUNED TUNED TIMER TIMER SLEEP SLEEP
BAND SELECT BAND SELECT A A— —PRESET PRESET MENU MENU DISPLAY DISPLAY CATEGORY CATEGORY
STANDBY STANDBY
ON/STANDBY ON/STANDBY POWER POWER
FM/AM TUNER ST7001 FM/AM TUNER ST7001
q t i !0