Miller Electric 852 - Manual (Page 19)

.
A complete Parts List is available at www.MillerWelds.com
OM-222 Page 15
4-4. Selecting A Location
1 Lifting Eye
2 Lifting Forks
Use lifting eye or lifting forks to
move unit.
If using lifting forks, extend forks
beyond opposite side of unit.
3
Rating Label (Non CE Models
Only)
Use rating label to determine input
power needs. Label located under
front access door.
4
Plate Label (CE Models Only)
Label located under front access
door.
5
Rating Label (CE Models
Only)
Use rating label to determine input
power needs. Label located on rear
access door (see Section 3-5).
6
Line Disconnect Device
Locate unit near correct input pow-
er supply.
Y Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
3
6
18 in
(460 mm)
18 in
(460 mm)
OR
1
2
Movement
Location And Airflow
4
5