Operating instructions, Health function, User caution – MRV Communications AE09~212FCAKA User Manual

Page 17

Advertising
background image

Operating Instructions

1 6

SWING

SET

LOCK

RESET

HEALTH

FAN

MODE

SLEEP

CLOCK

TIMER

ON

OFF

*

MODE

FAN

HEALTH

TEMP

CLOCK

SET

TIMER

SLEEP

RESET

FILTER RESET

ON/OFF

AM

SET

OFF

1.How to use the health function (only for units
with this function)
After set the right function mode, press health button,
remote controller or wire controller displays м о,
oxygen pump or negative ion generator starts up to apply
oxygen or negative ion to indoor unit. Press the button
again,the sign м о disappeared and negative ion generator
stops working. After all health function of the indoor unit
being fully canceled, oxygen pump stopped.

CAUTION:
When the temperature of the outdoor unit is lower than 4 ,
oxygen pump is automatically stopped, if press health button
just then, oxygen pump could not start up. But if the air
conditioner has the negative ion function simultaneous,
when press the health button, negative ion function could
still be operated. When the temperature of the outdoor unit
is higher than 6 , oxygen pump could automatically resume
to oxygen-make function.

AM

Power Failure Compensation (to be applied for a necessary situation) :

Setting Method: When the remote controller is on (excluding timer mode and fan mode),
press the "Sleeping" button on the remote controller 10 times within 5 seconds, and after the buzzer rings 4 times,
the air conditioner will enter the state of power failure compensation.

Cancel Method: Press the "Sleeping" button on the remote controller 10 times within 5
seconds, and after the buzzer rings 2 timer, the power failure compensation mode will be cancelled.

Notes: When a power failure suddenly occurs during the air conditioner is working after the power failure
compensation is set, if the air conditioner will not be used for a long time, please cut off the power supply to prevent
its operation from being resumed after the power is supplied again, or press the "Switch On/Off" button after the
power comes again.If the controller no sleep key ,use the "swing" key instead the "sleeping" on setting the auto
restart function.

After the power failure compensation is set, if power failure suddenly occurs while the air conditioner is working, it
will resume the previous working state when the power is supplied again.

On the "Health" mode, if you want to setting
timing open mode, should close the health
first: On the timing open mode, please don't
use health function.

About the remote cnotrol operation, above only take wired remote controller and remote controller (1) as a
example about the remote controller (2) and remote receiver use method, it is the same remote controller (1) ,
please use refer to above method.
No sleep function when use remote (2) and remote receiver.

SWING

Health Function

C

C

User Caution

Concerning MRV Auto Restart function for H-MRV models

Haier Auto Restart function when the unit power drops down suddenly, the unit microprocessor will store the previous

working condition and when the power is on again, the unit will run as this memory.

Auto Restart function is designed basically on the MRV whole system, but it is suitable for each indoor unit individually.

If some of indoor units power cut down, but the outdoor unit and the other indoor units still work, maybe problems

will happen such as freezing at cooling mode and overload protection at heating mode on those indoor units without power.
Reason

When one or some indoor units power drops down and the other indoor units are still work, the indoor units without

the power, will keep the previous working condition before the power is off. And expansion valve keeps open at a kind of
opening rate condition as the previous requirement, so there is refrigerant flowing in the exchanger, but the indoor fan stops
working. If the units work at cooling mode, the indoor units without the power will maybe make freezing. If the unit works
at heating mode, maybe the outdoor unit compressor will stop because of the pressure or temperature protection. This is
our design basically on Auto Restart function currently.
Haier, Herewith, solemnly informs our customers, installers, distributors, etc. when making installation, please make sure
when the power is shut down whether artificially or accidentally, the whole system including outdoor unit and all the
indoor units must be off. If you do not make the installation as our indication, Haier will not be responsible for any problem
resulting from this.

T E M P

FRESH

LIGHT

Advertising
This manual is related to the following products: