Remote controller (operation of remote controller) – MRV Communications AE09~212FCAKA User Manual

Page 7

Advertising
background image

1.This unit no the above function and display
2.The outdoor unit no oxygen-bar function ot no functions fo non-negative ion unit.
3.When using remote controller, first point it to the receiving window of wire controller, and then operate
remote controller.A ìtickî tone will be uttered to indicate a right acceptance.
4.All the buttons except the sleeping button is no effective after wire controller received lock signal from
remote controller.

6

Used to turn on/off unit
Note: Wired remote
controller his key have compl
cooling running function.

16.Fan speed display

19.Auto Swing display

26.Fresh air state display

15.Timer ON/OFF display

18.Clock display

23.Health state display

Auto

Low Fan Med Fan High Fan Auto

20.Humidifying state display

When the wire
controller appears
abnormal condition,
use a sharp-pointed
article to press this
button to make the
wire controller
resume normal

6.Time Adjusting button

11.Sleep button

7.Reset button

29.Lock state display

13.Setting button

Used to confirm
the time of timer
and clock

2.Operation mode button

4.Clock button

Used to calibrate the time

of timer and clock

24.Electric heating display

Used to set working mode:
Auto, Cooling,
Dehumidifying,

Heating, Fan

10.Fan speed button

Used to set fan speed: Low
Fan, Med Fan, High Fan, Auto

9.Temperature Setting button

8.Swing button

Used to set Auto Swing or
Fixed air sending direction

22.Working mode display

Working mode

Auto operation

Cooling operation

Dehumidifying
operation

Heating operation
Fan operation

Remote controller

5.Timer button

Used to set the
mode of timer

SWING

FRESH

SET

LOCK

RESET

LIGHT

HEALTH

FAN

T E M P

MODE

SLEEP

CLOCK

TIMER

ON

OFF

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

29

28

27

25

24

26

20

21

22

23

30

31

Make sure that the remote controller is used within 7 meters from receiver window of the wire
controller and there are no obstructions in between.
The remote controller or wire controller should be handled with care.
When operating the remote controller in an area where electronically controlled lights are installed
or wireless handsets are used, move closer to the indoor unit as the function of the remote controller
might be affected by signals from this equipment.

Used to set temperature,
temperature range: 16 C~30 C

Remote LCD display contents and key name and each key function introduction

3.Health

Used to control the
generating oxygen function
and negative ion-function

1.ON/OFF button

12.Fresh air

Used to set fresh air function

14.Lock button

Used to lock the operating
key and LCD contents

17.Battery energy display

21.Sleep mode display

Display when the health
running

25.Comfort running display

23.Temperature display

Used to display the setting
temperature and room temp.

27.Signal launch display

31.Signal lauch head

30.Light button

Used to realize control board
VFD light stable,light weaker,
light shut off etc.

8 12 17 19 20 24 25 26 30

Remote controller (Operation of remote controller)

3 23

Note:

SET

ROOM

MODE

FAN

TEMP

CLOCK

SET

TIMER

SLEEP

RESET

FILTER RESET

HEALTH

SWING

C

ON

OFF

*

AUTO

ON/OFF

D

Advertising
This manual is related to the following products: