MRV Communications AE09~212FCAKA User Manual

Page 8

Advertising
background image

7

T E M P

HEALTH

FAN

MODE

SWING

TIMER

ON

OFF

LOCK

RESET

Make sure that the remote controller is used within 7 meters from receiver window
of the wire controller and there are no obstructions in between.

The remote controller or wire controller should be handled with care.

When operating the remote controller in an area
where electronically controlled lights are
installed or wireless handsets are used, move
closer to the indoor unit as the function of the
remote controller might be affected by signals
from this equipment.

1.ON/OFF button
Used to turn on/off unit
2.Temperature Setting button

Used to set temperature,
temperature range: 16 C~30 C

4.Operation mode button

Used to set working mode:
Cooling, Dehumidifying,

Heating

5.Timer button

Used to set the
mode of timer

When the remote
controller appears
abnormal condition,
use a sharp-pointed
article to press this
button to make the
wire controller
resume normal

6.Reset button

7.Fan speed button

Used to set fan speed

8.Swing button

Used to set Auto Swing or
Fixed air sending direction

9.Time Adjusting button

11.Working mode display

12.Fan speed display

14.Timer ON/OFF display

18.Super/Soft operation display

Remote LCD display contents and key name and each key function introduction

3.Health

Used to control the
generating oxygen function
and negative ion-function

10.Lock button

Press on time lock all the
key sand press another time
concel the lock.

Used to display the fan
speed. After setting
"AUTO" function,air speed
can auto change according
to the temp. difference
between the room temp. and
setting temp.

20.Signal launch head

Use to send signal to the
indoor unit receive window.

19.Timing time display

Display timing open time
or timing close time

17.Lock display

Display the key have been
locked.

16.Temperature display

Display the setting temp.
value.

15.Signal display

Sending out signal to the
remote receiver.

13.Health running display

Used to display healthy
running.

R

Display Timing mode.
"Blank" No Timing
" " Timing off
" " Timing on

CODE

21.Code

Select remote control receive
code(H-MRV Remote cnotrol
type use A code)

OFF

ON

OFF

H

AUTO

ion

6

4

2

7

8

9

10

12

13

14

15

16

17

18

19

11

20

Note:
1.After change the battery, working condition resume as follows:
Working mode:cooling Temp. 26 C
Timming mode: normal Air speed: Auto
2.The units used in this manual no 8 18 functions. The health key can only control the
negative generator.

D

21

B A

Advertising
This manual is related to the following products: