Installation procedure, Installation of remote controller 27 – MRV Communications AE09~212FCAKA User Manual

Page 28

Advertising
background image

Installation of remote controller

27

5. Replace the upper cover of wire controller

Note

Try as far as possible a flat surface for installation.
Don't use excessive force when tightening screws,
or lower part might got deformed.

PCB is mounted on lower part of wire
controller, be careful not to damage it.

Hint 1. Power supply switch and signal wire should be prepaired by the user.

2. Don't touch PCB with hand.

Be careful not to hold down the wiring.

1. Remove upper cover of wire controller

Remove upper part of wire controller
by press.

Lower cover of wire

controller

Upper cover of wire

controller

2. Install the wired remote controller

Please drill two holes on the wall according to the
back cover screw hole position of the wire remote
controller, then strike the wood block to the holes
respectively, then align the 2 screw hole of the wire
controller back cover to the wood block, fasten the
wire reote controller to the wall use wood screws.

3. Switch setting

The switchs setting as follows:1.ON 2.OFF 3.ON 4.OFF

4. Connecting method as the following chart

Switch button

Screw hole

Back cover of the wire

controller

Installation Procedure

Use shielede wires for telecommunication
between wire controller and indoor unit;
indoor unit and outdoor unit. Ground the
shield on one side.
Otherwise misoperation because of noise
may occur.
Signal wire is self-provided by user.

Shielded wire

ground

No Symbol

colour

contents

1

2

3

4

A

B

C

D

White or Green

Red

Yellow

COM

Gnd

12V

Advertising
This manual is related to the following products: