Clock set, Battery loading batteries are fitted as follows – MRV Communications AE09~212FCAKA User Manual

Page 9

Advertising
background image

8

R

Battery loading
Batteries are fitted as follows:

Note:
It is recommended that the batteries be removed from the compartment if the remote
controller is not used for an extended period.
The remote controller is programmed for automatic test of operation mode after the
batteries are replaced. When the test is conducted, all icons will appear on the screen
and then disappear if the batteries are properly fitted.
When the display become weak, this display no power in the battery, please change the
battery.

Loading the battery
Ensure that batteries are correctly placed in the compartment as required for positive and
negative terminals.

Replacing the battery compartment lid
The battery compartment lid is reinstalled in the reverse sequence.

Display review
Press the button to see if batteries are properly fitted. If no display appears, refit the batteries.

Remove the battery compartment lid
Slightly press and disengage the battery compartment lid marked with м о and then hold
the remote controller by the upper section and then remove the battery compartment lid by
pressing in the direction of the arrow as shown in the figure above.

Caution:
If the remote controller does not operate as designed after fitting new batteries of the same
type, press the Reset button (marked ) with a pointed article.

Clock set

When unit is started for the first time, clock should be adjusted as follows:
Press CLOCK button, "AM"or "PM" flashes.
Press or to set correct time. Each press will increase or decrease 1min. If the
button is kept depressed, time will change quickly.
After time setting is confirmed, press SET, "AM "and "PM" stop flashing, while clock
starts working.

1 .Emergency switch
2 .Power lamp
After open the unit, this lamp bright when the
unite enter health running, the lamp change from
orange to blue lamp.
3 .Timing lamp
When the unit been setting Timing running, this
lamp bright.
4 .Running lamp
When the compressor working, this lamp bright.
5 .Indoor temp. sensor
Test the room temperature.

* *

* *

1

3

4

5

2

D

Advertising
This manual is related to the following products: