Miele KFN 8995 SD ED-1 - Manual (Page 39)

If the appliance was not disconnnected
from the electricity supply and the
light-coloured lines do not disappear,
contact the Miele Service Department.
. . . the alarm sounds, the
temperature display for the freezer
section is flashing, and
§% is
flashing in the door display?
The freezer section temperature has
risen above the set temperature
because
^ the freezer section door has been
opened too frequently, or large
amounts of fresh food have been put
in at once for freezing.
^ the ventilation slits are blocked.
^ there has been a lengthy interruption
to the power supply.
Once the problem has been resolved,
the freezer section temperature
indicator light will stop flashing and the
alarm will stop.
. . . a bar is lit up or flashing in the
temperature display(s)?
Check the temperature displays about
6 hours after switching on the
appliance. The display will not show
any temperature until the temperature
in the appliance has reached a certain
level.
. . . one of the display areas in the
door display is not lit up?
This is not a fault. The corresponding
section of the appliance is switched off.
. . . the door display does not light
up?
^ Check whether the appliance is
switched on.
^ Check that the plug connector
between the appliance door and the
appliance is working properly:
– Disconnect the appliance from the
electricity supply.
– Open the door to the refrigerator
section.
– Remove the cover from the bearing
block.
– Check the plug connector.
– Refit the cover over the bearing
block.
– Reconnect the appliance to the
mainn electricity supply.
If the appliance is switched on and the
plug connector is working properly, but
the door display is still not lit up, there
is a fault. Call the Service Department.
. . . "
F1" to "F5" appear in the
temperature display.
There is a fault. Call the Service
Department.
Problem-solving guide
39