Miele KFN 8995 SD ED-1 - Manual (Page 53)

^ Using flat-nosed pliers, carefully pull
the insert out together with the entire
cable loop.
Do not pull on the cable to remove
the insert - you could damage it!
^ Remove the stoppers and replace
them on the opposite side.
^ Replace the cable loop and insert on
the opposite side.
^ Screw the insert securely into
position.
^ Fit the covers back onto both sides.
Cover A (marked on the underside of
the cover) goes on the side with the
cable, Cover B on the other side!
^ Push the bearing bushing securely
into position until there is almost no
gap between it and the top of the
door.
Refitting the appliance doors:
^ Fit the stoppers into the top of the
freezer section door.
^ Hang the lower door on hinge pin j
and then close the appliance door.
^ Fit lower hinge bracket b in the door
bearing bushing of the lower door.
Then screw it securely to the
housing.
^ Refit cover a.
^ Fit the top appliance door onto
middle hinge pin j.
^ Open the door.
Changing the door hinging
53