Changing the door hinging – Miele KFN 8995 SD ED-1 User Manual
Page 51
Advertising
^ Remove the two screws from the top
of the bearing block.
^ Swing the door out to the side, then
lift it up and off.
Refitting the parts:
^ Unscrew bearing block e.
^ Remove cover f.
^ Refit cover f on the opposite side by
turning it 180° and then pushing it in
from the side. Netx, turn the earthing
contact g around and fit it on the
opposite side, too.
^ Fit the spacer bushings at the back
of the bearing block on the opposite
side.
^ Screw the bearing block onto the
opposite side.
^ Pull the grey cover on the bearing
block forwards (1) and push it into
the other side of the bearing block
(2).
Changing the door hinging
51
Advertising
This manual is related to the following products: