MITSUBISHI ELECTRIC WD-52825 - Manual (Page 43)

42 43
Edit NetCommand ® , Add an A/V Receiver, continued
Monitor Out to AVR Screen
Figure 11
Use this screen to select which A/V Receiver input is
connected to Audio 2 Monitor Output on the TV back
panel. Press ADJUST to select Next> and move to
the Finish screen.
Finish Screen
Figure 12
To finalize your selections and complete the A/V
receiver setup, select Finish from the Finish screen.
Note: If you connected the audio output of
a device directly to the A/V Receiver, you
must use the “Change” function of the Edit
NetCommand menu and select the device to
assign the correct A/V Receiver input to be
used with each device.
Name Screen
Figure 10
The Name screen allows you to change the default
name for the A/V receiver to a custom name of up to
eight characters (including a blank space), selecting
from letters, numbers, and nine different characters.
Using the TV’s remote, press ADJUST or to
select each letter, then press ENTER to move to the
next position. Press CANCEL to delete the current
letter and move back one character position. When
in the first position, the CANCEL button will return the
name to the default name.
Figure 10. Name screen
Figure 11. Monitor Out to AVR screen
Figure 12. Finish screen