MITSUBISHI ELECTRIC WD-52825 - Manual (Page 56)

56 57
NetCommand ® Controlled Recordings
Setting up Recordings
Figure 13
Through NetCommand, you can automatically start
and stop recordings and send signals from one
playback device to a recording device. Recordings
can be made on recordable devices connected to the
TV or to the internal TV Disc. The TV Disc is an IEEE
1394 hard disk drive, with 120 GB of memory and is
available for CableCARD™, Ant 1, Ant 2, IEEE 1394
or tuning devices (cable boxes or satellite receivers)
connected to inputs 1, 2, 3 when a PIP or POP is not
displayed.
The TV can convert digital channels and IEEE 1394
device signals to analog signals that can be recorded
on NetCommand compatible analog VHS and S-VHS
VCRs.
You can schedule the recording to take place at a
later time and program the recording duration for a
minimum of 30 minutes and a maximum of 6 hours (in
30 minute increments). The default is 1 hour. During
the recording, the TV can be powered Off. If the TV is
powered On, it will be tuned to the source that is being
recorded. The TV should remain on this source to
ensure the recording continue without interruption.
Recording Now
Can be used when viewing Antenna 1 or 2, an IEEE
1394 device including TV Disc, or a non-recording
traditional device.
To initiate recording now:
1. Press REC (record) on the TV remote.
2. Press DEVICE on the remote control to move to the
Source Device section.
3. Press ADJUST , , or to select the source
device you will record from. If a source is not
displayed, it is not available as a recording source.
4. Press ENTER to confirm selection and return to the
“Record to” section.
5. In the “Record to” section, review the destination
device and duration. Use ADJUST or to
change, if necessary.
6. Press a second time and the recording will start.
Time-Delayed Recording
1. Press REC (record) on the TV remote.
2. Press DEVICE on the remote control to move to the
Source Device section.
3. Press ADJUST , , or to select the source
device you will record from.
4. Press ENTER to confirm your source device
selection and move to the Record to section.
5. Press ADJUST or to select the Record to
device, duration time, start time (press ENTER after
selecting hour, minutes and AM or PM to set the
time) and day, using ADJUST or to change,.
For devices that can select channels, select the
channel.
6. Select Add and press ENTER to add the recording
to the record list. If your selection is successful, a
confirmation message will be displayed. If you pick
overlapping times, day(s), or destination devices,
you will see a message stating there is a conflict.
7. To exit, press HOME on the TV remote after all
recordings have been added.
Figure 13. Record to screen