Multi-Tech Systems MTA128ST-USB - Manual (Page 24)

24
MultiModemISDN User Guide
MTA128ST-USB
ISDN MTA128ST-USB Configuration Utility
Use the ISDN MTA128ST-USB Configuration Utility with computers running Windows 98/
95 operating systems only. Because it is a software utility, you can use it to create and
store as many different configurations as you wish.
To Install in Windows 98/95
1. When installing from disk, insert the Setup disk (provided in your MTA128ST-USB
package) into drive A or B. If installing from a network location, connect to it. (Note
the drive letter. You may need it if you run Setup again.)
2. Click Start, Settings, and then click Control Panel.
3. Double-click the Add/Remove Programs icon.
4. In the Install/Uninstall tab, click Install.
5. Follow the instructions that appear on screen.
To Use the ISDN MTA128ST-USB Configuration Utility
1. To start the utility, click Start, Programs, and then double-click the ISDN MTA128ST-
USB Configuration Utility icon. The ISDN TA Configuration Wizard is displayed.
Select the type of Setup (e.g., Express (Existing), Configuration (e.g., EuroISDN),
and then click Next >. Follow the instructions provided in each succeeding dialog
box.
2. Refer to the “Network Configuration” topic notes in the previous section as you
configure the unit. If you have questions about choices in a dialog box, click Help.
3. When you finish configuring the MTA128ST-USB, exit the configuration utility.