Multi-Tech Systems MTA128ST-USB - Manual (Page 7)

7
Chapter 1 - Introduction and Description
MTA128ST-USB
Manual Organization
This manual is divided into six chapters and two appendixes:
Chapter 1: Introduction and Description—Summarizes product features, lists
technical specifications, and provides an overview of manual’s organization.
Chapter 2: Installation—Describes how to connect the MTA128ST-USB to the
computer, to power, to the ISDN BRI line, and to an optional analog device. It also
describes the functions of the front panel LED indicators.
Chapter 3: Software Installation and Configuration —Describes how to install the
driver software and how to configure and operate the MTA128ST-USB using the
Windows 98/95 software configuration utility.
Chapter 4: AT Commands, S-Registers, and Result Codes—Describes how to use AT
commands, S-registers, and result codes to control the MTA128ST-USB through popular
communications programs.
Chapter 5: Troubleshooting—Provides tips and advice if you think your MTA128ST-
USB isn’t working correctly.
Chapter 6: Warranty, Service, and Technical Support—Provides terms of your
warranty and describes how to get your MTA128ST-USB serviced at the factory, should
that be necessary. It also describes how to upgrade your unit using the FlashPro utility,
and how to get technical support and information by phone, the Multi-Tech BBS, and
Internet forums.
Appendix A: Regulatory Compliance—EMC, Safety, and Terminal Directive
Compliance.
Appendix B: Configuration Profiles—Describes how to use the Quick Setup Factory
Profiles stored in the MTA128ST-USB’s firmware and lists contents of each profile.