Multi-Tech Systems MTA128ST-USB - Manual (Page 40)

40
MultiModemISDN User Guide
MTA128ST-USB
Command: $MBn
Function:
V.110 Network Rate
Values: n = 600, 1200, 2400, 4800, 9600, 19200, 38400
Default: $MB38400
Description: If S77=1, then the network rate of the V.110 connection will match that of
$MB (S76). If a V.110 call is received and S77=1, then the incoming V.110
network rate must match $MB (S76) or the connection will fail. If S77=2 and
a V.110 call is originated, then the network rate will match that of $MB (S76).
If S77=2 and a V.110 call is received, then the setting of $MB (S76) will have
no effect on the network rate of that call (see S77 for a description for this
case). The value of $MB will change if S76 is changed and the value of S76
will change if $MB is changed.
Command: %En
Function:
Escape Sequence Options
Values: n = 0–5
Default: %E1 and %E4
Description: By default, the TA responds only to the +++ escape method. However, you
can use the %E command to set the TA to respond only to the <break>
method, to respond to either the +++ or the <break> method, or to ignore
both methods and not escape.
%E0
Modem won’t escape
%E1 +++ escape method
%E2 <break> escape method
%E3 Both +++ and <break> escape methods
%E4 Disable OK response to +++
%E5 Enable OK response to +++
%E1 %E5 Enable +++ method and OK response to +++
%E3 %E5 Enable +++ or <break> method and OK response to +++