McIntosh MVP871 - Manual (Page 48)

48
To exit the Memory 1 Adjust 1 Mode press the SELECT
Push-button. To make additional video adjustments, use
the Right directional Push-button to select Memory 1
Adjust 2 and press the SELECT Push-button. If no other
adjustments are to be made at this time, exit by pressing
PIC ADJ Push-button. Refer to figure 87.
8. Press the
Down
directional
Push-but-
ton to
activate
the Picture
White
Level Set-
ting; use
the Up
or Down
directional Push-buttons to adjust the brightness of
White Areas of the image from a setting of -5 to +5.
9. Press the Right directional Push-button to select the
Picture Black Level Setting. Use the Up or Down
directional Push-buttons to adjust the darkness of the
colors in the dark areas of the image from a setting of
-5 to +5.
Note: The Black Level adjustment is active for the Com-
ponent Video Outputs with the Progressive Scan
Mode active and HDMI Outputs.
10. Press the Right directional Push-button to select the
Chroma Level Setting. Use the Up or Down direc-
tional Push-buttons to adjust the intensity of the Colors
in the image from a setting of -6 to +6.
11. Press the Right directional Push-button to select the
Enhancer Setting. Use the Up or Down directional
Push-buttons to adjust contours of the image from a
setting of -0 to +11.
Note: The Enhancer adjustment is active for the Com-
ponent Video Outputs with the Progressive Scan
Mode active and HDMI Outputs.
To exit the Memory 1 Adjust 2 Mode press the SELECT
Push-button. To make additional video adjustments, use
the Right directional Push-button to select Memory 1
Adjust 3 and press the SELECT Push-button. If no other
adjustments are to be made at this time, exit by pressing
PIC ADJ Push-button. Refer to figure 88
12. Press the Down directional Push-button to activate
the Dynamic Noise Reduction (DNR) Setting; use the
Up or Down directional Push-buttons to adjust the
reduction of noise in the image from a setting of 0 to
+3.
access the
Memory
1 Picture
Adjust 1
Settings.
Refer to
figure 86.
3. Press the
Down
directional
Push-but-
ton to
activate
the Picture
Contrast
Setting;
use the
Up or
Down
directional
Push-but-
tons to
adjust the
Contrast from a setting of -6 to +6.
4. Press the Right directional Push-button to select the
Picture Brightness Setting. Use the Up or Down
directional Push-buttons to adjust the Brightness from
a setting of 0 to +12.
5. Press the Right directional Push-button to select
the Picture Sharpness (Mid) which effects the range
of medium frequencies in the Video Signal. Use the
Up or Down directional Push-buttons to adjust the
Sharpness from a setting of -6 to +6.
Note: The Sharpness (Mid) is not active for the HDMI
Outputs only.
6. Press the Right directional Push-button to select
the Picture Sharpness (Hi) which effects the range of
high frequencies in the Video Signal. Use the Up or
Down directional Push-buttons to adjust the Sharp-
ness from a setting of -6 to +6.
Note: The Sharpness (Hi) is active for the Component
Video Outputs with the Progressive Scan Mode
active and HDMI Outputs.
7. Press the Right directional Push-button to select the
Picture Hue (Tint) Setting. Use the Up or Down
directional Push-buttons to adjust the Hue from a set-
ting of -6 to +6.
Note: The Hue Setting is not active for the Component
Video Output with the Interlaced Mode active.
MVP871 Video Settings and Adjustments, con’t
Figure 85
Figure 86
Figure 87