Marantz PD4298HD s - Manual (Page 18)

8
ENGLISH
Handling the Remote Controller
Loading Batteries
The life of the batteries used with the remote control unit is about 6
months with normal use. Also be sure to replace batteries earlier when
you notice that they are getting weak. Do not use alkaline, manganese,
nickel-cadmium (Ni-Cd) or other different types of batteries together.
1) Remove the back cover.
2) Insert the new batteries (AA type) with correct (+) and (-) polarity.
3) Close until it clicks.
CAUTIONS
■ Do not drop or impact the remote controller.
■ Do not splash the remote controller with water or put it on a wet object
to avoid possible failures.
■ Before leaving the remote controller out of use for an extended period of
time, remove the batteries from it.
■ If the remote controller begins to lack responsiveness, replace the
batteries.
■ Strong light such as direct sunlight impinging on the photoreceptor of
the remote control can cause operational failure. Position this unit to
avoid direct contact with such light.
■ Do not use new and old batteries together. The batteries could explode
or leak, resulting in fires, physical injury, or stains.
■ When loading batteries, observe their correct polarities as marked on the
product. If loaded in the wrong direction, the batteries could explode or
leak, resulting in fires, physical injury, or stains.
TIPS
Handling the Remote Controller
●
Use the remote controller within about 15 feet from front of the
unit’s remote-control receiver and within 30 degrees on both sides.
With in 30
degrees
With in 30
degrees
About 15 feet
ENT ENT
CH VOL OK
CD DVD CD-R/MD
DSS TV VCR AUX
LD TUNER TAPE AMP
CLEAR MEMO GUIDE MUTE AUTO DOLBY THX DTX HALL 1 2 3 4 5 MATRIX MOVIE 2CH OSD SLEEP 6 7 8 9 0
POWER ON ON/OFF OFF SOURCE
MACRO MODE LEARNING REMOTE CONTROLLER RC1200
INSTALLATION INSTRUCTIONS (continued)