Motorola HDT100 - Manual (Page 47)

42
Problem Possible Solution
After installing the
HDT100 and running
Auto Scan, not all the
available channels
have been added Add the missing channels manually. See “Adding a
Channel” in the On-Screen Menu section.
You may have to reposition your antenna to receive all
the local channels, especially if different transmit
towers are being used by the networks. For more
information, log on to the following web site:
http://www.antennaweb.org/
Cannot lock on a
signal when manually
adding a channel Verify the channel number is correct.
Check the antenna and make sure it is aligned to the
correct direction.
Check the signal’s strength and quality. Press INFO to
display the i-Banner and review the color bars at the
bottom of the window. If any of the bars are red, adjust
your antenna and try again.
No Closed Captions Verify that the channel you are watching carries closed
captioning.
Cannot receive
channels after
changing the
HDT100’s location You may have to reposition your antenna. Consult the
following web site:
http://www.antennaweb.org/
On-Screen Error Messages
Bad Signal Check to be sure that the antenna cable is connected
properly (hand-tighten if necessary).
Check the antenna and make sure it is aligned to the
correct direction.
Scrambled Channel The program you are watching is scrambled by the TV
station. The program cannot be decoded by the
HDT100.