Multi-Tech Systems RF102S - Manual (Page 9)

Software Installation
9
Software Installation and Configuration
Before beginning the installation process, ensure that your
system meets all hardware and software requirements:
• Intel 486 or higher processor.
• 10/100 BaseT cable to connect the RF102S to the network.
• One or two asynchronous analog modems or ISDN terminal
adapters (also known as ISDN TA), or one of each .
• A networked computer with Windows 95/98/2000, Windows
NT 3.5 or higher and TCP/IP protocol installed.
• Any Windows communication application for Dial-Out
operation.
• TCP/IP installed and configured on each workstation
accessing the Internet.
Software Installation
The software installation process involves installing the
RouteFinder Utilities, including RouteFinder Setup Wizard,
RouteFinder Manager, and RouteFinder Monitor. A description
of each component follows. Refer to the User Guide for more
information.
RouteFinder Setup Wizard
The RouteFinder Setup Wizard provides a step-by-step process
to assist you in entering all the basic settings needed to
configure your RF102S for general use. All settings that are
entered in the Setup Wizard can be found in their respective
menus in RouteFinder Manager.
RouteFinder Manager
RouteFinder Manager is the main program used to configure all
settings for your RF102S.