Multi-Tech Systems MT2834MR6 - Manual (Page 25)

25
Chapter 3 - AT Commands
Table 3-1. AT Commands by Function (con't)
Topic: Command: Description:
&E10 Non-error correction mode flow control off
&E11 Non-error correction mode flow control on
&E12 Pacing off
&E13 Pacing on
#X Number of XOFF characters sent
Escape +++AT<CR> Default in-band escape sequence
Sequences <BREAK>AT<CR> Alternate out-of-band escape sequence
%E Escape sequence selection
A Force answer mode
O Go back online
Remote %%%AT<CR> Remote configuration escape sequence
Configuration #I Change login password
#S Change setup password
Line Probes %DP Read line probe data
%DF Format line probe data
&RP Immediate line probe
L9 Display signal strength
L10 Display signal to noise ratio
L11 Display noise strength
Diagnostics &T Respond to remote digital loopback signal
U Loopback test modes