Multi-Tech Systems MT2834MR6 - Manual (Page 99)

99
Appendix
&CDn n = 0 or 1 Cleardown at Disconnect
*** &CD0 Enable cleardown.
&CD1 Disable cleardown.
Ds s = phone # Dial
Dial telephone number
s , where s may include up to 60 digits or T, P, R, comma,
colon, and semicolon characters.
DsNd s = phone # Store Phone Number
d = 0 or 1 To store, enter D followed by telephone number s , then N followed by directory
number d .
&Dn n = 0, 1, 2, Data Terminal Ready Control
or 3 &D0 Modem ignores DTR signal.
&D1 When DTR drops, the modem hangs up. While DTR is low, the modem accepts
commands but will not dial or auto-answer until DTR goes high again.
*** &D2 Same as &D1 .
&D3 When DTR drops, the modem hangs up and resets as if an ATZ or an AT&F
command was issued.
%DCn n = 0 or 1 Command Mode Control
*** %DC0 Enable command mode.
%DC1 Disable command mode.
%DFn n = 0 or 1 Line Probe Data Format
*** %DF0 V.34 line probe data displayed in graph format.
%DF1 V.34 line probe data displayed in table format.
%DPn n = 0 or 1 Line Probe Data Read
*** %DP0 Disable reading of line probe data during the V.34 handshake.
%DP1 Enable reading of line probe data during the V.34 handshake.
>DTn n = 0 or 1 DTMF Detection
*** >DT0 Disable DTMF detection.
>DT1 Enable DTMF detection when off-hook.
En n = 0 or 1 Echo Command Mode Characters
E0
Do not echo command mode characters.
*** E1 Do echo command mode characters.