Miller Electric Legend AEAD-200-LE - Manual (Page 43)

TM-428 Page 39 Miller Legend
After tuning engine, check engine
speeds with a tachometer. See
table for proper no load speeds. If
necessary, adjust speeds as fol-
lows:
Start engine, and place Engine
Control switch in Run/Idle position.
Turn Fine Amperage control to
100.
1 Carburetor
2 Throttle Solenoid
Power/Idle Speed Adjustment
3 Power/Idle Speed Rod
4 Lock Nut
5 Adjustment Nut
Loosen lock nut and rotate adjust-
ment nut until engine runs at pow-
er/idle speed. Tighten lock nut.
Weld Speed Adjustment
Place Engine Control switch in Run
position.
6 Lock Nut
Loosen nut.
7 Hex Swivel
Turn swivel until engine runs at
weld speed. Tighten lock nut.
8 Weld Speed Governor Spring
9 Power/Idle Speed Governor
Spring
If a spring becomes loose or dis-
connected, reattach as shown.
8-5. Adjusting Engine Speed
Tools Needed:
1860 rpm
(Power/Idle)
3000 rpm
(Weld)
3/8 in,
8, 11 mm
ST-116 049-C
Rear View
Top View
2
3 4
5 9
1
8 6 7
2