4. trigger hold switch – Miller Electric SS-74S12 User Manual

Page 22

Advertising
background image

OM-1500−11 Page 18

5-4. Trigger Hold Switch

1

Trigger Hold Switch

Trigger hold allows the operator to weld with-
out holding the gun trigger.

To use the trigger hold function, place the

trigger hold switch in the On position.

The operator must hold the trigger for a mini-

mum of 2 seconds, but not longer than 6

seconds before releasing it. Welding will

continue when the trigger is released.

To stop welding, press the trigger again.

1

803 152

5-5. Voltage Control And Digital Meters (For Models With Meters Only)

3

803 152

1

2

1

Voltmeter

Displays actual or preset voltage

from welding power source through

the 14−pin control cable.
2

Wire Speed Meter

Factory set to display inches per

minute. If display of meters per min-

ute is desired, see Section 4-13.
3

Voltage Control

Use control to adjust voltage output

of welding power source.

Advertising
This manual is related to the following products: