Metrologic Instruments Solaris MS7820 - Manual (Page 16)

12
Figure 5.
Keyboard Wedge Interfaces
³ 9 9 9 9 9 8
Recall Defaults
I
NSTALLATION
C
ABLE
I
NSTALLATION
(I
NTERFACE
S
PECIFIC
)
Keyboard Wedge
1. Turn off the host system.
2. Disconnect the keyboard from the host.
3. Connect the keyed VLink cable to the
10-pin Multi-Interface jack. It is the only
circular keyed jack located on the bottom
of the MS7820
(see figure 5).
4. Connect the “Y” end of the
VLink cable to the keyboard
and the keyboard port on the host.
If necessary, use the male/female
adapter cable supplied with the scanner for
proper connections.
Before continuing, verify the
VLink cable is connected to the
appropriate interface jack on the scanner.
An incorrect cable connection can cause
communication problems or potential
damage to the scanner.
5. Connect the external power supply
to the power jack on the scanner.
6. Check the AC input requirements
of the power supply to make sure
the voltage matches the AC outlet.
7. Connect AC power to the transformer.
The outlet should be near the equipment
and easily accessible.
8. Scan the Recall Defaults bar code
to configure the MS7820 for
Keyboard Wedge communication.
9. Turn on the host system.
10. Snap on the cable cover.
See SELV Power caution statement located on page 11 of this manual.