MITSUBISHI ELECTRIC EN-1 - Manual (Page 8)

EN-8
1 Start the Projector-Control Device Installer.
• Select [Start] - [All Programs] - [Mitsubishi] -
[Mitsubishi Projector - Control Device Installer] (in
the case of Windows
® XP).
2 Press the + buttons on the left pane to expand the
tree structure until the IP address you set appears.
3 Click the Telnet Confi guration tab.
4 Select the Connect tab. Press the Enter key within
5 seconds after the message shown on the right
appears.
• When it passes 5 seconds without any operation
on this screen, the screen is shaded and no key
operation is accepted. In this case, click the
Connect button again to continue setting.
5 The setting menu appears.
Telnet setting
Setting of password, display language, LAN control, and PJLink™ certifi cation using telnet.
This section describes how to set the password, display language on the ProjectorView screen, LAN control, and
PJLink™ certifi cation that are necessary for the operation state control tool (commercially available) that uses the
projector operation control/monitor tool ProjectorView and the industry standard PJLink™ protocol.
Preparation/SetUp (continued)