MITSUBISHI ELECTRIC EN-1 User Manual
Page 15
EN-15
Initial setting
To load information on the projector such as model name and lamp operating time, set the projector data in
advance. Click the SETUP button on the ProjectorView main screen. The Projector Setup screen appears. Enter
data according to the description of each setting item.
(Note 4)
You can’t change the Projector model, Serial number, Operating hours, and Lamp hours.
Each setting item is described as follows:
ProjectorView (continued)
Projector name*
Name to identify the projector
Projector model
Model name of the projector
Projector location*
Location of the projector
Serial number
Serial number of the projector
SMTP IP address*
IP address of the SMTP server used for e-mail transmission (Example: 192.168.0.1)
E-mail address*
e-mail address to receive alert notifi cation e-mail (Example: [email protected])
E-mail host*
User-defi ned string displayed at the Internet header of e-mail message (Example: user)
E-mail from*
Sender of alert notifi cation e-mail (Example: [email protected])
Operating hours
Cumulative projector operating time
Lamp hours
Cumulative lamp operating time calculated on the “Low” lamp mode basis.
Installation date*
Date when the projector was installed
Last lamp replacement date* Date when the lamp was last replaced
Last maintenance date* Date when the projector was last maintenanced
Virtual remote enabled
Display or hide the virtual remote controller (Check the box to display.)
* ) For data entry, use alphanumeric characters and symbols (+ - / = @ * _ ! ? . , ; : # $ % & ( ) | < > [ ] { } " ').
(Note 5)
When the “Standard” lamp mode is selected, the indicated lamp operating time may exceed the indicated
operating time. For example, when you use the projector in the “Standard” mode for 2 hours, the lamp operating
time is indicated as 5 hours.