Marantz DV4001 - Manual (Page 10)

Connecting Up 2
10
Connecting audio/video cables
Be sure to insert each
plug fully for the best
con nec tion. The plugs
and jacks are color-cod ed
to make con nec tion
easier.
Connecting system control cables
By connecting this DVD player to another
Marantz audio component using a supplied
system control cable, you can remotely
operate the components as a single system.
• When con nect ing to a com po nent with a
remote sensor, be sure to connect the REMOTE
CON TROL IN jack of this DVD player to
the REMOTE CON TROL OUT jack of the
com po nent with the remote sensor.
• When connecting to component which is
not equipped with a remote sensor, be sure
to connect the com po nent to the REMOTE
CONTROL OUT jack of this DVD player.
Easy setup
This easy setup is the minimum set of
connections you need to start watching
DVD-Video discs. Both sound and picture
are fed directly to your TV using the
sup plied audio/video cables. For other
possible con nec tions, see pages 11 and 12.
Important
• Before making or changing any rear panel
connections, make sure that all components are
switched off and unplugged from the wall outlet.
• While a connected component is turned on,
do not unplug the power cord of this DVD
player from the wall outlet. The speaker may be
damaged.
Note
• When connecting to a standard TV, select
4:3 LETTER - BOX or 4:3 PAN SCAN in the TV
Aspect setting (see page 38).
• Connect the video output of the player directly
to your TV. Because the player is de signed to
support an Analog Protection System copy card,
there are cases when proper playback will be
not be possible if the player is connected to the
TV through a VCR and images are recorded and
played on the VCR.
• The player’s video output and S1 output are not
be progressive.
• Remote switch
When using this DVD player independently, set
this switch to INT. (INTERNAL). When using this
DVD player in a system with a Marantz receiver
equipped with a remote sensor, set the switch to
EXT. (EXTERNAL).
• Flasher Input
This is used when controlling components
from different rooms with a keypad or other
input device. Set the remote switch to EXT.
(EX TER NAL) when using a fl asher input.
REMOTE CONTROL
Ver 1.0 AUDIO
L
COMPONENT
B
R Y
C COAX. HDMI
INT. EXT.
OUT
IN
ANALOG AC IN
RS-232C
S1
FLASHER
IN
VIDEO
C
R
A/V EUROCONNECTOR
2 1
3
EXT. INT.
Connect to a composite video
input on your TV using the
supplied Audio/Video cable.
Plug into a standard
AC wall outlet.
Connect to a pair of stereo
audio inputs on your TV using
the sup plied Audio/Video cable. RS-232C terminal/
FLASHER IN
Control terminal for use by
custom installers.
See Note:
Remote Switch