Motorola CAJUN P120 - Manual (Page 59)

Chapter 6 Legacy CLI (Command Line Interface)
Cajun P120 User’s Guide 45
Using the SHOW Command
The show command is used to display the current settings for a particular group of
parameters. If you have never changed parameter settings, then these are the
factory default values.
The following example will display the current settings for the IP group:
CajunP120> show ip
Listing the Groups You Can Set
If you enter set on the command line, a list of the groups that can be set with this
command displays.
Note: This is useful for displaying the syntax for use in your configuration.
The available groups are:
CajunP120-priv# set
Group list:
mibII-syst MIB-II system group params
Cam Cam parameters
ip Management IP parameters setup.
IP-multi-
cast
IP-multicast parameters
STA-GEN Parameters for configuring general spanning tree.
STA-PORT Parameters for configuring spanning tree per port.
P120 Port configuration group
vlan Vlan group
copy-port Destination (network analyzer) and source ports setup
tftp TFTP parameters setup.
snmp Configuration of SNMP community names and trap
managers