Motorola CAJUN P120 - Manual (Page 73)

Chapter 6 Legacy CLI (Command Line Interface)
Cajun P120 User’s Guide 59
P120 Port Configuration Group (P120)
This group includes parameters for the configuration of switched ports. The table
below shows the parameter names, default values, range of values, and value to be
used with the index keyword.
The syntax for this command is:
set|show P120 <all|port#> list
Table 6.11 P120 Group Parameters
Parameter Description
Default
Value(s)
Valid Range for Values
ADMIN Enables the port
to forward frames ena dis, ena
DUPLEX Duplex type and
speed depending
on the device to
be connected auto (if sup-
ported), full
(for 1000M
ports) 100-half, 100-full,
10-half, 10-full, auto
REDUNDANT Creates up to 4
redundant pairs none 1 primary, 1 backup
2 primary, 2 backup
3 primary, 3 backup
4 primary, 4 backup
LAG Sets link
aggregation none base, link, none
FLOW-CONTROL Enables flow
control dis ena, auto, dis
HOLB-P Allows early
packet drop dis ena, dis
PORT-PRI Sets port priority regular regular, high
PORT-VLAN Sets port VLAN 1 1-255
VLAN-MODE Sets VLAN
tagging No tagging (no
802.1q tagging) tagging, no tagging