Metrologic Instruments Stratos MS2xxx Series - Manual (Page 16)

11
S
CALE
/L
OAD
C
ELL
C
ONFIGURATION
B
AR
C
ODES
Dual Cable Scale Configuration Bar Codes
Scale Protocols
The following bar codes will change scale parameters intended for a
Dual Cable environment. To place the scanner in Dual Cable mode,
please refer to page 20.
The MS2xx0 must be in scale program mode to use these bar codes.
Scale = EPOS Protocol
³ 9 9 6 0 1 3
Set the scale RS232 protocol to
Serial EPOS.
Communication Port Settings:
• 2400 Baud
• 7 Data Bits
• 1 Stop Bit
• Even
Parity
Scale = EPOS2 Protocol
³ 9 9 6 0 1 4
Set the scale RS232 protocol to
Modified Serial EPOS.
This Protocol does not require the POS
terminal to send the weight back to the scale
for validation.
Communication Port Settings:
• 2400 Baud
• 7 Data Bits
• 1 Stop Bit
• Even
Parity