Metrologic Instruments Stratos MS2xxx Series - Manual (Page 63)

58
S
CANNER
C
ONFIGURATION
B
AR
C
ODES
Auxiliary Port
Quick Start for a Secondary Metrologic Scanner
The following codes do not require that the MS2xx0 to be in scale
program mode.
S
TEP
1
Use the Stratos to scan the following bar code. This bar code will configure
the Stratos’ auxiliary port to accept a Metrologic scanner as the secondary
scanner.
Enable Stratos Auxiliary Port
³ 4 3 7 3 2 0
The auxiliary input port’s data format must match the main output format
of the secondary scanner
S
TEP
2
Configure the secondary scanner to match the auxiliary port’s data format.
Use the Secondary Scanner to scan the following bar codes in the order
shown.
Enter Configuration Mode
³ 9 9 9 9 9 9
Enable Auxiliary Output
³ 1 2 4 8 1 7