Adjusting/replacing anti-tipper, Figure 7.5 – Invacare Top End X-Terminator QR User Manual
Page 66
SECTION 7—FOOTREST/ ANTI-TIPPER
Everyday and Sport Series Wheelchairs
66
FIGURE 7.5 Adjusting the X-terminator and Transformer Footrests - Transformer Height
Adjusting/Replacing Anti-tipper
ƽ WARNING
Anti-tippers MUST be attached at all times. Inasmuch as the anti-tippers are an
option on this wheelchair (you may order it with or without the anti-tippers),
Invacare strongly recommends ordering the anti-tippers as an additional safeguard
for the wheelchair user.
Anti-tippers MUST be fully engaged. Ensure the release button of the anti-tipper
fully protrudes out of the hole in the anti-tipper socket.
Ensure both anti-tippers are adjusted to the same height.
NOTE: For this procedure, refer to FIGURE 7.1.
NOTE: To ensure the correct model anti‐tipper is used refer to FIGURE 7.1. Measurements for
anti‐tippers are approximate and are taken using the top adjustment hole on the anti‐tipper
(Detail ʺAʺ).
Footrest
Tubing
Half Clamp
Mounting Screw
Adjustment Holes
Half Clamp
Coved Washer
Coved Washer
Mounting Screw/
Threaded Sleeve