Invacare Top End X-Terminator QR - Manual (Page 73)

SECTION 9—WING/BUMPER
Part No 1114851 73 Everyday and Sport Series Wheelchairs
SECTION 9—WING/BUMPER
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
NOTE: The following procedures are for Transformer wheelchairs ONLY.
Installing/Removing the Wing/Bumper
NOTE: For this procedure, refer to FIGURE 9.1.
Installing
1. Slide wing/bumper clamps onto caster housing on the Transformer. Ensure the wing
or bumper is even on both sides.
2. Tighten allen screws securely on each side.
Removing
1. Loosen allen screws on wing/bumper clamps.
2. Slide up and remove.
FIGURE 9.1 Installing/Removing the Wing/Bumper
Wing/Bumper
Caster Housing
Allen Screws
Bumper/Wing
Clamp