Invacare ARROW MWD - Manual (Page 49)

49
B
A
T
T
E
R
I
E
S
FIGURE 9 - INSTALLING/REMOVING GROUP
22 BATTERY BOX
Battery Box
Retention Strap
Arrows
FIGURE 8 - INSTALLING/REMOVING GROUP
24 BATTERY BOXES
Battery Box
Sub-Frame
Two (2) Connector
Battery Box
One (1) Connector Battery Box
NOTE: Position
carrying strap on top
of battery box
Guide Pins
Guide Pins
Battery Box
Retainer Bar
INSTALLING/REMOVING GROUP
22 BATTERY BOX (FIGURE 9)
NOTE: This procedure is for MWD/RWD chairs ONLY.
NOTE: To install the battery box onto the wheelchair, re-
verse the following procedure.
1. Place the wheelchair in a well ventilated area where
work can be performed without risking damage to car-
peting or floor covering.
2. Verify that the ON/OFF switch on the joystick is in the
OFF position.
3. Disconnect the battery cable from the outside of the
battery box.
4. Disconnect the battery box retention strap.
5. Remove the battery box.
6. Slide the four (4) clips that secure the battery box cover
to the battery box to the OPEN position.
NOTE: Arrows on the battery box cover point to the open
position.
7. Remove battery box cover from the battery box.
*NOTE: Illustration depicts base frame for RWD and
MWD models. Batteries remove/Install for the Arrow
FWD in the same manner.
*Base Frame
*Base Frame
NOTE: Make certain that the carrying strap of the first
battery box installed is positioned on top of the battery box
and will not interfere with the second battery box guide
pins during installation.
5. Place one (1) connector battery box onto battery sub-
frame.
6. Slide one (1) connector battery box along the sub-
frame until its guide pins are engaged in the connec-
tor of the two (2) connector battery box.
7. Secure the battery box carrying strap to the lid of the one
(1) connector battery box.
NOTE: Visually inspect to ensure the connection is
properly made. Connectors MUST be fully engaged.
CAUTION
The battery box retainer MUST be locked
(clipped) securely to hold the battery
boxes firmly in place or battery box con-
nectors may be damaged causing er-
ratic chair operation.
8. Pull the battery box retainer down over the end of
front battery box until it is securely clipped (locked)
into place.
PROCEDURE 9 BATTERIES