Invacare ARROW MWD - Manual (Page 84)

84
Spacer
Battery Mount
Bracket
Rubber Element
Mounting
Screw
Base
Frame
FIGURE 7 - RUBBER ELEMENT REPLACEMENT
Mounting Screw
(LOOSEN)
EQUIPMENT OPTION
CONVERTING TORQUE AND X
RUBBER ELEMENTS TO ARROW
SHOCKS (FIGURE 8)
1. Remove the battery box. Refer to INSTALLING/REMOV-
ING GROUP 22 BATTERY BOX in PROCEDURE 9
of this manual.
2. Remove the existing Torque and X rubber element. Re-
fer to RUBBER ELEMENT REPLACEMENT -
TORQUE AND X BASE FRAMES in this procedure of
the manual.
3. Line up the bottom of the new Storm Arrow shock with
the BOTTOM hole in the rubber element mount plate.
4. Install the new hex screw and locknut through the bot-
tom hole of the mount bracket and shock. Torque to
160-inch pounds.
NOTE: The original hardware that secured the BOTTOM of
the Torque and X rubber element to the shock mount bracket
will not be used with this option. Keep for future use.
5. Reinstall the hex screw that secures the top of the shock
assembly and battery mount bracket to the base frame.
Use Loctite 242 and torque to 160-inch pounds.
6. Torque the hex screw that secures the battery mount
bracket to the base frame to 160-inch pounds.
7. Reinstall the battery box tray onto the battery mount
bracket and torque the locknut to 160-inch pounds.
8. Reinstall the battery box. Refer to INSTALLING/REMOV-
ING GROUP 22 BATTERY BOX in PROCEDURE 9
of this manual.
Battery Mount
Bracket
Shock Hex Screw
FIGURE 8 - CONVERTING TORQUE AND X RUBBER
ELEMENTS TO ARROW SHOCKS
RWD WHEELCHAIRS PROCEDURE 16
R
W
D
W
H
E
E
L
C
H
A
I
R
S
RUBBER ELEMENT REPLACEMENT
(FIGURE 7)
NOTE: Rubber elements are only found on Storm
Torque and Storm X wheelchairs.
1. Remove the battery box. Refer to INSTALLING/REMOV-
ING GROUP 22 BATTERY BOX in PROCEDURE 9
of this manual.
2. Remove the battery box tray. Refer to REMOVING THE
BATTERY BOX TRAY in this procedure of the
manual.
3. Loosen the mounting screw that secures the battery
mount bracket to the base frame, but do not remove.
4. Remove the mounting screw that secures the top of
the rubber element and battery mount bracket to the
base frame.
6. Remove the three (3) mounting screws and locknuts
that secure the bottom of the rubber element to the rub-
ber element mount bracket.
7. Remove the existing rubber element and install the new
rubber element.
8. Resecure the bottom of the rubber element to the rub-
ber element mount bracket with the existing three (3)
mounting screws. Use Loctite 242 and torque to 160-
inch pounds.
9. Reinstall the hex screw that secures the top of the rub-
ber element and battery mount bracket to the base frame.
Use Loctite 242 and torque to 160-inch pounds.
10. Torque the hex screw that secures the battery mount
bracket to the base frame to 160-inch pounds.
11. Reinstall the battery box tray onto the hanger bracket
and torque the locknut to 160-inch pounds.
12. Reinstall the battery box. Refer to INSTALLING/REMOV-
ING GROUP 22 BATTERY BOX in PROCEDURE 9
of this manual.