Infinite Peripherals KPM-210 - Manual (Page 14)

1. INSTALLATION AND USE
KPM210/216 2 1-
1.2 CONFIGURATION
This printer permits the configuration of default parameters. The printer’s
configurable parameters are:
• Interface (1) : RS232 D , USB (if present).
• Baud Rate (2) : 57600, 38400, 19200 D , 9600, 4800, 2400, 1200.
• Data length (2) : 7, 8 D bits/char.
• Parity (2) : None D , even or odd.
• Handshaking (2) : XON/XOFF D or Hardware.
• Receive buffer size (2) : 16, 64, 1K, 4K, 8K D bytes.
• Autofeed: CR deactivated D or CR activated.
• Print mode: Normal D or Reverse.
• Characters per inch:
204 dpi version: A=11 B=15 cpi
D , A=15 B=20 cpi.
300 dpi version: A=17 B=23 cpi D , A=23 B=30 cpi.
• Speed/Consumption: Low, Medium D , High.
• Paper retract at power-up (3) : Deactivated D or Activated.
• Print density: -50%, -37%, -25%, -12%, Normal D , +12%, +25%,
+37%, +50%.
Please note: the parameters marked with the symbol D represent the default
values.
(1) N.B.: This parameter is displayed if the printer has an USB
interface.
(2) N.B.: If the printer has an USB interface, the serial interface
configuration parameters are not displayed.
(3) N.B.: If, at power-up, paper is present on the ejector and if this
parameter has been activated, the printer will retract the paper.
Otherwise, if the parameter is deactivated, the printer will eject
the paper.
The settings made are stored in EEPROM (nonvolatile memory).
During power-up, if the FORM FEED key is held down, the printer enters the
autotest routine and prints out the setup report. The printer will remain in
standby in Hexadecimal dump mode (see section 1.3) until another key is
pressed or characters are received through the printer communication port.
When the FORM FEED key is pressed, the printer enters parameter
configuration.
When the LINE FEED key is pressed, the printer exits setup and terminates
the Hexadecimal dump function.
(Tab.A.3)
www.ipcprint.com