3 hexadecimal dump, 4 maintenance, 1 changing the paper roll – Infinite Peripherals KPM-210 User Manual

Page 15

Advertising
background image

1. INSTALLATION AND USE

KPM210/216

3

1-

When the receive buffer is full, if handshaking is set to XON/XOFF, the
printer sends the XOFF ($13) on the serial port.
When the receive buffer has cleared once again, if handshaking is set to
XON/XOFF, the printer sends the XON ($11) on the serial port.

1.3 HEXADECIMAL DUMP

This function is used to display the characters received from the
communications port; the printer prints out both the hexadecimal code
received as well as the corresponding ASCII code.
Once the autotest routine has finished, the printer enters Hexadecimal Dump
mode. The printer remains in standby until a key is pressed or characters are
received from the communications port; for every 24 characters received
(204 dpi version) or every 32 characters received (300 dpi version), it prints
hexadecimal values and ASCII codes (if the characters appear underlined, it
means the receive buffer is full).

Shown below is an example of a Hexadecimal Dump for the 204 dpi (24
character) version:

1.4 MAINTENANCE

1.4.1 Changing the paper roll

To change the roll of paper, proceed as follows:
1)

Position the paper roll (1) so that it unrolls correctly as shown in fig.1.2;

2)

Insert the end of the paper roll in the paper load opening on the printing
mechanism (2) and wait for the paper to load automatically (see fig. 1.2);

3)

Remove the paper from the paper exit opening (3)

(4)

.

(4)

N.B.:

The paper exit opening may be assembled in one of two

positions, depending on the model in use (see fig. 1.2).

48 65 78 61 64 65 63 69 6D 61 6C 20 64 75 6D 70 20 66 75 6E 63 74 69 6F

Hexadecimal dump functio

6E 20 30 31 32 33 34 35 36 37 38 39 61 62 63 64 65 66 67 68 69 6A 6B 6C

n 0123456789abcdefghijkl

6D 6E 6F 70 71 72 73 74 75 76 77 78 79 7A

mnopqrstuvwxyz

www.ipcprint.com

Advertising
This manual is related to the following products:

216