Infinite Peripherals KPM-210 - Manual (Page 19)

1. INSTALLATION AND USE
KPM210/216 7 1-
- Re-tighten the fastening screws (2).
WARNING
• Assemble the side guides so that they are aligned and perpendicular to
the paper load opening.
1.4.4 Paper jams
In the event of a jam along the paper path, proceed as follows:
Turn the printer on and off before removing the paper in order to cut the
paper and attempt to have it ejected.
If this does not solve the problem, proceed as follows:
Paper jammed on ejector (see fig. 1.8):
1) Lift the roller cover (1) .
2) Remove any pieces of paper present in the ejector rollers (2).
3) Remove any paper present in the paper exit opening
(5) .
(5) N.B.: The paper exit opening may be assembled in one of two
positions, depending on the model in use (see fig. 1.2).
Paper jammed before the cutter (see fig. 1.8), lift the paper guide (3) and
perform one of the two operations below:
1) Lift the head lever (4) and pull the paper back (5); remove any pieces of
paper.
2) Remove the print head (see section 1.4.5) and pull the paper back (5);
remove any pieces of paper.
www.ipcprint.com