Icom IC-F21GM - Manual (Page 24)

17
4
SET MODE
D D SETTING THE CTCSS TONE FREQUENCY (continued)
• CTCSS confirmation beep
●; Single beep
; Long beep
Push [PTT]
no
1 (Once)
2 (Twice)
3 (Third)
4 (Fourth)
Confirmation beep
●
●
●●
●●●
●●●●
Push [PTT]
5 (Fifth)
6 (Sixth)
7 (Seventh)
8 (eighth)
9 (ninth)
Confirmation beep
●●●●●
●
●●
●●●
●●●●
D D SETTING THE DTCS CODE
This transceiver is equipped with 83 DTCS codes. DTCS operation
provides communication with silent standby since you will only re-
ceive calls from group members using the same DTCS number.
You can assign different numbers to CH 1 to CH 15 independently.
q While pushing and holding [PTT], [MONI], [W/N], turn [OFF/VOL]
to power ON.
w Select the desired CH 1 to CH 15 that you want to assign the
DTCS code to.
e Push and hold [W/N] until a beep (Pi) is emitted.
r Push [PTT] the necessary number of times to choose the 100
digit of the desired code number.
t Push [MONI].
• Confirmation beep is emitted. (See p. 17)
y Push [PTT] the necessary number of times to choose the 10 digit
of the desired code number.
u Push [MONI].
• Confirmation beep is emitted. (See p. 17)
i Push [PTT] the necessary number of times to choose the 1 digit
of the desired code number.
o Push [MONI].