Intel KM4AM - Manual (Page 39)

3 - 6
MS-6734 M-ATX Mainboard
If you select Manual, related information is asked to be entered to the following items.
Enter the information directly from the keyboard. This information should be provided
in the documentation from your hard disk vendor or the system manufacturer.
Access Mode The settings are CHS, LBA, Large, Auto.
Capacity
The formatted size of the storage device.
Cylinder
Number of cylinders.
Head Number of heads.
Precomp Write precompensation.
Landing Zone Cylinder location of the landing zone.
Sector
Number of sectors.
Drive A:/B:
This item allows you to set the type of floppy drives installed. Available options:
None
, 360K 5.25, 1.2 MB 5.25, 720 KB 3.5, 1.44 MB 3.5 and 2.88 MB 3.5.
Video
The setting controls the type of video adapter used for the primary monitor of the
system. Available options: EGA/VGA , CGA 40, CGA 80, MONO.
Halt On
The setting determines whether the system will stop if an error is detected at boot.
Available options are:
All Errors
The system stops when any error is detected.
No Errors
The system doesn’t stop for any detected error.
All, But Keyboard The system doesn’t stop for a keyboard error.
All, But Diskette The system doesn’t stop for a disk error.
All, But Disk/Key The system doesn’t stop for either a disk or a key-
board error.
Base/Extended/Total Memory
The three items show the memory status of your system (read only).