Integra DTR-8.2 - Manual (Page 24)

24
R L
SURR
BACK
/ ZONE 2
SPEAKERS
When using the ZONE 2 OUT terminals
When you have connected all the speakers for 7.1-channel audio in
the main room, connect the speakers as shown below.
The ZONE 2 OUT terminal is a constant output. Connect to the
LINE input of the amplifier (CD, tape, etc.). Adjust the volume
with the amplifier connected to the ZONE 2 OUT terminal.
1. Connect the DTR-8.2 to the amplifier for the remote
zone.
2. Connect the remote zone speaker cables to the
speaker terminals on the amplifier.
Adjust the volume level at the amplifier.
3. Connect the DTR-8.2 to the monitor for the remote
zone.
When using the SURR BACK/ZONE 2 SPEAKERS
terminals
If you are using a 5.1-channel speaker system in the main room, you
can connect the speakers for the remote zone (Zone 2) to the open
SURR BACK/ZONE 2 SPEAKERS terminals.
With this connection, select “Activated” for the Speaker Setup
→
Powered Zone 2 setting in the Setup menu (See page 32).
Note:
It is important to be aware of the speaker impedance (see previous
page).
Connecting the remote zone (Zone 2)
speakers
Outline
The DTR-8.2 allows you to connect another set of speakers and
place them in a different room or separated area for listening to
music. This other room or area is referred to as the remote zone
(Zone 2), while the room where the DTR-8.2 is located is the main
zone. In addition, the IR IN/OUT allows you to control the DTR-
8.2 from the remote zone (Zone 2) with the remote controller even
though the remote zone is physically separated. The diagram
below shows how to make the proper connections for the remote
zone.
Note:
The ZONE 2 OUT terminals of the DTR-8.2 are of a fixed output
level.
Remote Zone (Zone 2) Main Room
Zone 2
Right
speaker
Zone 2
Left
speaker
When using the SURR BACK/ZONE 2 PRE OUT
terminals
If you are using a 5.1-channel speaker system in the main room, you
can connect the amplifier for the remote zone (Zone 2) to the open
SURR BACK/ZONE 2 PRE OUT terminals and connect the remote
zone speakers.
With this connection, select “Activated” for the Speaker Setup
→
Powered Zone 2 setting in the Setup menu (See page 32).
PRE OUT
FRONT
SUB
SURR
CENTER
R L
SURR
BACK /
ZONE 2
Remote Zone (Zone 2) Main Room
Zone 2
Right
speaker
Zone 2
Left
speaker
Power amplifier
Left (white)
Right (red)
AUDIO VIDEO S VIDEO
MONITOR
OUT
R L
OUT ZONE 2
Remote Zone (Zone 2)
Main Room
Zone 2
Right speaker
Zone 2
Left speaker
Zone 2
monitor or
projector
Zone 2 amplifier
Left (white)
Right (red)
DTR-8.2
DTR-8.2
DTR-8.2