Integra DTR-8.2 - Manual (Page 53)

53
+
–
CH
VOL
MUTE
CONT
+
–
LIGHT
Phones Zone 2 Level Stereo Surround THX DSP Rec Out Zone 2 Off Dimmer FM Mode Memory Setup
Clear
Enter Return Video 5/Video Cam Input Tuning Preset
S Video Audio Video L R Didital
Master Volume Standby/On
Power
On O f f
Video 1 Video 3 Tape FM AM Phono CD DVD Video 2 Video 4 Video 5 Zone 2 ( ) GRN Rec ( ) RED Pure Audio psampling U
Standby
Display Audio Selector
Direct/ Pure Audio
Dimmer
+/–
Sleep
Dim
Display
CH Sel
Enjoying music or videos with the DTR-8.2
Using the sleep time (remote controller only)
The Sleep button enables you to set the DTR-8.2 to turn off
automatically after a specified time period. If you press it once, the
DTR-8.2 will turn off after 90 minutes. Each time it is pressed
thereafter, the remaining time until the DTR-8.2 turns off decreases
by 10 minutes. While, the sleep function is enabled, you can press
the Sleep button to see how much time is left. To cancel the sleep
function, press the Sleep button when the time displayed is less than
10 minutes.
If you are using the remote zone (Zone 2), it will turn off at the same
time as the main zone. If you want to set the sleep function for Zone
2 only, set the sleep function with main zone turned on and then put
the main zone into the standby state.
Temporarily changing the speaker output levels
To change the individual speaker volumes temporarily, follow the
procedure given below. Each channel can be set between –12 to +12
decibels. Note that the calibration settings will return to the original
settings when the DTR-8.2 is put in standby.
1. Press the CH Sel button and select
the desired speaker.
2. Press the + or – button to adjust the
volume level.
Remote controller
Notes:
• You cannot select a speaker if the Speaker Config sub-menu of
the Speaker Setup is set to No or None.
• If the speaker level is set to +1 dB or higher, the maximum level
indicated on the display will change if you raise the volume
level.
• When you press the Test button after you set the level, the
current level will be used as the value set via the test tone.
Input source buttons
Adjusting the brightness of the front display
You can adjust the brightness of the front display of the DTR-8.2
with the Dim button on the remote controller or the Dimmer button
on the DTR-8.2 front panel.
DTR-8.2 Remote controller
Dimmer
When using the remote controller, select AV Amp in the Home menu to
display the operation menu. Then tap the down scroll button twice to
display the third operation menu (Dim, Sleep, CH Sel, and +/–) or tap
the down scroll button to display the next operation menu (Display).
Switching the display
While listening to or watching an input source, you can display the
information regarding the type of source and signal being input by
pressing the Display button on the DTR-8.2 or the remote controller.
When an input source other than FM or AM is selected:
* If the input signal does not have a program format, then this will
be skipped.
Input + volume
Program format*
Input +
Listening mode
or Multi Ch
When FM or AM is selected as the input source:
FM/AM frequency +
Preset no.
FM/AM +
Listening mode
DTR-8.2
ch
Display
Remote controller