Intermec PB50 User Manual
Page 63
Chapter A — Specifications
PB50 Mobile Label and Recept Printer User’s Guide
53
Receipt roll stock media is supplied as a continuous roll. Label, tag,
and fanfold media use repeat indicators for non-continuous media.
Gap, notch, and black marks are used as repeat indicators:
•
Gap: Label and fanfold media
•
Notch: Tag media
•
Black mark: Label, tag, and fanfold media
Here are a few things to keep in mind when ordering media for the
PB50 printer:
•
Black marks can only be sensed on the back side of the media.
•
You can use higher caliper media in the printer, but print quality
will be reduced.
•
Receipt roll stock media has an end of roll indicator. The end of
roll indicator is a red marking (on last 3 feet of roll) on the
thermally sensitive side of the paper.
Media Specifications
Core inside diameter, standard:
19 mm (0.75in)
Core inside diameter, with adapter:
10.2 mm (0.4 in)
Maximum roll outside diameter:
67.3 mm (2.65 in)
Media width, label with liner/receipt:
49mm (1.9 in) to 111.5 mm (4.4 in)
Media length, label:
25.4 mm (1.0 in) to 609.6 mm (24 in)
Media length, receipt:
Continuous
Media caliper, label with liner/receipt:
0.05 mm (0.002 in) to 0.165 mm (0.0065 in)
Media caliper, tag (maximum):
0.15 mm (0.006 in)
Gap length (centered on perforation):
3.17 mm (0.125 in) to 12.7 mm (0.50 in)
Notch length (centered on perforation):
6.35 mm (0.25 in)
Notch width (centered on perforation):
12.7 mm (0.50 in)
Black mark length (centered on perforation):
3.17 mm (0.125 in) to 12.7 mm (0.50 in)
Black mark width (centered on media width):
Full width of media