IBM SY27-0345-06 - Manual (Page 53)

2
If the IBM 2210 is installed in a rack, remove the screws attaching the IBM
2210 to the rack.
3
Remove the two screws that attach the mounting brackets to either side of
the IBM 2210. Then remove the center screw that attaches the cover to the
side of the IBM 2210. Note the position of the mounting bracket ears as you
remove the mounting brackets.
Figure 4-1. Removing the Side Screws
4
Position the IBM 2210 so that the port side is facing you. From this position,
lift the rear portion of the cover and slide it away from you.
Figure 4-2. Removing the Cover
5
Be sure to store the mounting brackets and screws with the cover.
Chapter 4. Removal and Replacement Procedures 4-3