IBM SY27-0345-06 - Manual (Page 91)

5
Attach the 14.4 Kbps Modem Port Feature to the system board by inserting
the alignment post through the top of the modem and screwing in the post.
6
Using the two screws from the blank faceplate secure the front of the Modem
Card faceplate to the frame of the 2210.
7
Replace the cover as described in “Reinstalling the Cover” on page 4-4.
8
Verify the IBM 2210 is functioning correctly by using “MAP 0210: Verify
Operation” on page 2-23.
Removing the 14.4 Kbps Modem Port Feature in Models 14T and 24x
1
Remove the cover from the IBM 2210 as described in “Cover” on page 4-2.
2
Remove the two screws that secure the 14.4 Kbps Modem Port Feature to
the IBM 2210 frame.
3
Unscrew the alignment post and remove it from the modem.
4
Remove the 14.4 Kbps Modem Port Feature connection from the system
board.
5
Lift the 14.4 Kbps Modem Port Feature out of the IBM 2210 chassis.
Chapter 4. Removal and Replacement Procedures 4-41