IBM SY27-0345-06 - Manual (Page 64)

Fan Cable
LED Panel Cable
Power Supply Cable
Reset Cable
AC Power Ground
AC Power Cable
Figure 4-17. Attach Cables to the System Board - 14T Models
Fan Cable
LED Panel Cable
Power Supply Cable
Reset Cable
AC Power Ground
AC Power Cable
Figure 4-18. Attach Cables to the System Board - 24x Models
7
To attach the LED panel cable, slide the cable into the connector making
sure that the blue coloring on the end of the cable faces the blue latch. Be
sure to slide the cable into the latch as far as possible. Press down on the
blue retaining latch to secure the cable.
8
Replace the Adapter Enablement Feature, if installed. See “Installing the
Adapter Enablement Feature” on page 4-35 for the installation procedure.
9
Attach the reset card cable to the system board.
4-14 2210 Service and Maintenance