Invacare CROSSFIRE T6 - Manual (Page 30)

SECTION 6—BACK
Crossfire™Series Wheelchairs 30 Part No 1148078
SECTION 6—BACK
ƽ WARNING
ALWAYS perform these procedures in the presence of an assistant. The position of
the footrest, camber tube, back angle, the tautness of the back upholstery as well as
the user's condition are directly related to the wheelchairs stability. Any change to
one or any combination of the five may cause the wheelchair to decrease in stability.
Use EXTREME caution when using a new seating position. The addition of
anti-tippers may be required.
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Unfolding/Folding the Back
ƽ WARNING
Back MUST be locked securely in place before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 6.1
1. To unfold the back, lift up on the back canes and pull back towards the rear of the
wheelchair until it locks into place.
2. To fold the back, pull up on the back release cord and push the back canes forward
toward the front of the wheelchair.
FIGURE 6.1 Unfolding/Folding the Back
Back Angle Adjustment
NOTE: For this procedure, refer to FIGURE 6.2 on page 31.
NOTE: Perform this procedure on both sides of the wheelchair at the same time.
Front of
Wheelchair
Rear of
Wheelchair
Back Cane
Back Release Cord
(Not Shown)
NOTE: Back upholstery
removed for clarity.