Invacare CROSSFIRE T6 - Manual (Page 44)

SECTION 8—WHEELS
Crossfire™Series Wheelchairs 44 Part No 1148078
Repositioning the Camber Tube Mounting Brackets
NOTE: For this procedure, refer to FIGURE 8.7.
1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 38.
2. Loosen but do not remove the four socket screws and washers that secure the two
camber tube mounting brackets to the camber tube supports.
3. Slide the camber bar forward or backward to adjust the wheelbase length to the
desired position.
4. Securely tighten the four socket screws and washers that secure the two camber tube
mounting brackets to the camber tube supports.
5. Install the rear wheels. Refer to Removing/Installing Rear Wheels on page 38.
FIGURE 8.7 Repositioning the Camber Tube Mounting Brackets
Repositioning the Camber Tube Mounting Bracket Socket Screws
CAUTION
When reinstalling the two socket screws, ensure one empty mounting position
remains between the two socket screws.
NOTE: For this procedure, refer to FIGURE 8.8 on page 45.
1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 38.
2. Refer to Socket Screw Mounting Positions in FIGURE 8.6 to determine which socket
screw(s) must be moved and to which mounting positions.
3. Remove the four socket screws, washers, and lock washers from both camber tube
mounting brackets.
Socket Screws
Washers
Camber Tube
Support
Camber
Tube
Camber Tube
Mounting Bracket
Socket Screws
and Washers
Camber
Tube Support
Camber Tube
Mounting Bracket