Invacare Allegro 1061057 - Manual (Page 16)

16
This Procedure includes the following:
Installing Footrests
Adjusting Footrest Height
Installing 3-inch Extension
Installing Elevating Legrests
Raising/Lowering Elevating Legrests and/or
Adjusting Calfpads
Installing/Adjusting Adjustable Angle
Flip-up Footplates
Replacing Sector Block
Optional Footrest Accessories
Pivot Slide Tube Height Adjustment (FIGURE 2)
1. Remove any accessories that are attached to the
footrests.
2. Remove the hex screw and coved washer and posi-
tion the footrest assembly to the desired height.
3. Lineup the mounting hole in the footrest support,
reinsert the hex screw and coved washer and se-
curely tighten.
4. Repeat STEPS 1-3 for the other footrest.
5. Reinstall any accessories that are attached to the
footrest.
Hex Screw
Coved Washer
Footrest
FIGURE 2 - PIVOT SLIDE TUBE HEIGHT
ADJUSTMENT
FIGURE 3 - FOOTPLATE HEIGHT ADJUSTMENT
(70 O MFX AND 90 O FOOTRESTS ONLY)
Locknut
Footplate Height Adjustment (70 o MFX and 90 o
Footrests Only) (FIGURE 3)
1. Remove any accessories that are attached to the
footrests.
2. Remove the socket bolt, coved washer and
locknut that secure the footplate to the footrest
support.
3. Reposition the footplate to the desire height.
WARNING
DO NOT overtighten. Footrest must be able to
rotate upward from the horizontal to vertical
position.
4. Reinstall the socket bolt through the mounting
holes of the footplate and footrest support.
5. Secure the footplate to the footrest support with
the coved washer and locknut.
F
R
O
N
T
R
I
G
G
I
N
G
S
PROCEDURE 1 FRONT RIGGINGS
Height Adjustment
Holes
Socket Bolt
Footplate
Footrest Support
ADJUSTING FOOTREST HEIGHT
NOTE: Release the footrest locking mechanism and
lift the mounting pin out of the mounting tube. Lay
the assembly on a flat surface to simplify procedure.
FIGURE 1 - INSTALLING FOOTRESTS
Mounting Pin
Footrest
Release
Lever
Mounting
Tube
Footrest
NOTE: All swingaway style footrests are installed the same
way. Only one (1) style of footrest is shown for clarity.
Footplate
WARNING
After adjustments, and before use, make sure
all attaching hardware is securely tightened.
INSTALLING FOOTRESTS (FIGURE 1)
1. Turn the footrest to the side (open footplate is
perpendicular to wheelchair).
2. Insert mounting pin into mounting tube.
3. Push the footrest towards the inside of the
wheelchair until it locks into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat this procedure for the opposite footrest.
5. To release the footrest, push the footrest release
lever inward, rotate footrest outward.